Installation instructions for Osdag in Ubuntu.
=========================================================================================
System Requirements:

    Operating System: Ubuntu 18.04 (LTS) and later; 64-bit
    Hardware Requirements:
        Minimum 4 Gb RAM
        Minimum of 4 Gb of free disk space

 
=========================================================================================
Installation steps:

Extract the downloaded installer using the Archive Manager/File-Roller, or using 
the following command on the bash prompt:

	tar -xvf Osdag_ubuntu_installer_v2021.02.a.a12f.tar.gz
 
 
Note: If you have already installed the  previous version of Osdag in your system then delete the same.
It is mandatory to execute Commands 1 and 2 to successfully install this version of Osdag. 
If you have LaTeX installed you may skip Step/Command 3.
 
In bash, navigate to the extracted installation folder containing the shell 
scripts (the folder that contains this README file) and a folder named Osdag, 
and enter Command 1, Command 2 and Command 3 given below.  

 
Note: After entering Command 1, while installing Miniconda3, you will be asked  
whether you wish to set the system default python to Miniconda3. You need to agree  
to this, in order for the second command to work. After installing Miniconda3 close the terminal.
Re-open the terminal at the same location and execute Command 2 and/or Command 3 respectively.

You will need internet connection to execute Step/Command 3.

    Step/Command 1:
        bash 1-install-Miniconda3-latest-Linux-x86_64.sh
        
    Step/Command 2:
        bash 2-install-osdag.sh
        
    Step/Command 3:
	bash 3-install-texlive.sh
    
=========================================================================================
Running Osdag:

    After the installation is complete, you may copy/move the extracted Osdag folder
to a location of your choice (say, directly under your home folder).
    
    Using the Command:
        In the bash prompt, navigate to the Osdag directory and enter the following command
        
        python osdagMainPage.py

=========================================================================================
Note: Step/Command 2 will work only if the system default python is the one installed through Miniconda3.


